Hydraulic guillotine shears

Hydraulic guillotine shears are designed for straight longitudinal and transverse cutting of sheets of steel and non-ferrous metals.

Hydraulic guillotine shears consist of the following units:

• durable welded monoblock frame structure that can withstand heavy loads;
• work table with ball guides;
• hydraulic pressure cylinders that press the sheet of metal being processed along the entire length of the cut;
• movement of the back stop using an electric drive, with subsequent precise finishing along the limb;
• The upper and lower knives of the hydraulic sheet guillotine shears are made of high-strength, hardened steel, have two cutting edges, and after turning 180 allow cutting with knives without resharpening.

The frame is made of assembled and welded parts.

To facilitate feeding the sheet into the cutting area, extensions and ball bearings are fixed on the table.

For cutting workpieces at an angle, one of the extensions has an angle stop.

Two balancer to hold the knife beam in the upper position.

The rear stop drive is attached to the inside of the posts. The hydraulic guillotine for cutting metal is equipped with a mechanism for mechanically adjusting the gap between the knife blades depending on the thickness of the material being cut.

The gap is adjusted from one workstation by moving the table, while the thickness of the sheet being cut is indicated on the limb.

The pressure beam is attached to the posts of the bed.

The knife beam is made of one piece, has a reciprocating movement and tilts from right to left.